1.材質:鋼管シェルの材質は通常20鋼またはQ235鋼です。
2.セラミックパッチの形態には、溶接タイプ、モザイクタイプ、セルフ-アーチタイプ、ダブテール相互圧力セルフ-ロックタイプ、インサートタイプ、スパイラルタイプがあります。
3.パイプの直径:100mm以上。
4.耐熱性:300度以下。
5.適用分野:電力、鉱業、石炭など。
6.サイズ:厚さ-シェル鋼管5-12mm、ライニングセラミック厚さ5-25mm、一般的な10mm;
7.利点:
(1) High hardness: Rockwell hardness is HRC80-90, the hardness is second only to diamond, far exceeding the wear resistance of wear-resistant steel and stainless steel;
(2) High wear resistance: The wear resistance is equivalent to 266 times that of manganese steel and 171.5 times that of high-chromium cast iron;
(3) Light weight: The density of the ceramic sheet is 3.9g/cm3, which is only half of that of steel, which can greatly reduce the load of the equipment;
(4) High purity: alumina content: Greater than or equal to 95 percent
8.接続方法:フランジ、V -コネクタ、溶接セクション。
9.高コストパフォーマンス:同じ作業条件下で、セラミックパッチ複合パイプの使用はバイメタル複合パイプよりも適しています。
10.注意事項:耐衝撃性はありません-。 輸送および設置中の衝突防止に注意してください。 一般的に、包装ラックや包装箱などの包装には密閉包装が必要であり、ストローロープで包まれているものもあります。 リフティングイヤーを取り付けることをお勧めします。






